The first task is to wind the window down fully! Then remove the window winder handle by prising it off with a screwdriver.
Then prise off the door-pull handle as shown...
Now remove the lock handle surround as shown on the left.
Having removed all the trims, you can now undo the concealed screws
Now remove the door-trim by placing your knee on the lower section and pulling on the upper section as shown
With the trim removed, disconnect the speaker wires.
Now remove the rubber window strip as shown in the photo's shown below
Now you need to remove the door-lock retaining clip by dislodging it with a screwdriver. Please note that this will not be replaced when re-assembling.
With the retaining clip removed, you can now withdraw the actual door lock mechanism.....
Placing the zinc-coated plate over the door-lock hole as shown in the photograph and mark the door for drilling.
Please note that because the door is double-skinned, you will need to drill a pilot-hole before using your larger drill-bit
Once you have completed the drilling, protect the area by applying a small amount of touch-up paint to the drill holes..
Having drilled the holes, you can now prepare to fit the plates. First of all apply the rubber gasket to the back of the stainless-steel frontplate and apply a small amount of silicone around the threaded studs.
Then insert the zinc backplate into the door and refit the door-lock mechanism as shown in the photo. This will hold the backplate in position...
You can now attach the stainless-steel frontplate and secure it with the supplied Nyloc Lock-Nuts.
Once the Nyloc nuts are tightened (do not overtighten), then you simply need to check the alignment of the keyhole and if necessary, gently tap the plate with a soft-faced mallet.
Whilst every effort has been made to
ensure this document contains no errors or misleading information, LocksOnline or Armaplate
cannot accept responsibility for any damage caused by third-party installation
work
