Fullex 68 PZ uPVC Lever Handles with Snib - 244mm (215mm fixings)

These are the snibbed Fullex handles designed with uPVC doors using Fullex multipoint locks in mind, however they can of course be used on any multipoint lock that may use the same design footprint with regards to the 68mm PZ measurement and 215mm fixing centres. 

If your handle's overall backplate length measures 244mm (or 245mm) and has a 68mm PZ measurement, then this is likely to be the handle set you need.  A quick double-check of the other measurements will confirm, bearing in mind that the screw fixing centres are quite crucial, as these have to pass above and below the multipoint lock's centre gearbox, or in some cases through the gearbox in very specific positions so it's important to match these up with your existing screw holes where possible.

One distinct identifier and unique function is the little slider snib located on the side of these handles.  This adds a layer of passive security to the handles allowing you to lock the handles up in a basic way.

When purchasing these handles, you will be supplied with spring cassettes and an 8mm square spindle, so you've everything you need to fit the handle in place!

These are non-handed and therefore you do not have to consider the handing of your door before purchasing!

Our product specifications are given in good faith but can be subject to manufacturer change without notice. Should an attribute be of essense to your purchase, please feel free to contact us first for confirmation.