Code Change Instructions
The door must be open.
|1. Turn the outside thumbturn to the left (counterclockwise) to the stop position; then release. This will clear any random entries from the mechanism.Note: When the thumbturn is turned to the left on a deadbolt model, the bolt is automatically thrown into the locked position; therefore, it is important to keep the door open while changing the combination.2. Enter the existing combination. On new installations, use the factory-set combination: depress 2 and 4 simultaneously, (release), then 3 (release). You should feel a slight click as each button is depressed.|
3. Use the Allen wrench to remove the screw from the top of the lock housing (see figure 1).
4. After removing the screw. Insert the Allen wrench into the hole and depress the internal lockout slide; you should feel a slight click. Do not force.
5. Remove the wrench.
6. Turn the outside thumbturn to the left (counterclockwise) to the stop position, then release.
7. Choose your new combination, write it down, then enter the new combination — depress buttons carefully (a slight click should be felt as each button is depressed).
Note: You can use one button or all five for a combination, but each button can only be used once. You can depress two or more buttons simultaneously as a step in the combination.
Symptom/problem: Turning outside thumbturn always retracts latch/bolt without depressing without any buttons.
Cause: Lock is in zero combination.
Solution: Follow the procedure for changing a combination, but omit step 2.
Simplex Unican Locks and Simplex Unican Accessories available from Locksonline.